Some features are disabled because JavaScript is turned off on your browser

Get Your Custom Hinge Here

Call 800-344-6437 or fill this form

9 + 7 =

Custom Hinge Selection Tool

Welcome to Hinge Guru Select Hinge Type Select Operation Step 3: Select Customization
Select Customization Here

More Operations : Reverse Assemble

Normally, hinges are assembled so that both leaves are on the same side of the pin.

However, Guden can supply the hinge with the leaves assembled on opposite sides of the pin for what is called a reverse assemble. Literally, the pin is extracted, one leaf is reversed, and the pin is reinserted.

This configuration is advantageous if you require an offset between the leaves but do not want to swage the leaves which can slightly lower the durability and strength of the material.

If the starting hinge has an even number of knuckles (as most standard length hinges do), there will be one knuckle of waste when reverse assembling, shown here in color. The excess is cut off.

Reverse Assembly has the disadvantage of being slower and more expensive than "swage to reverse" operation. This is because it requires considerable manual work, and if the pin is retained it may be difficult to remove, and the issue of extra waste and cutting described above.

Hinge Guru Image